How to Set Up a Top Rope: Rope Length and Throwing the Rope

Top-Rope Anchors Learning Centre

Lesson 8 of 9

Top-Rope Anchors

Rope length, lowering from the middle and getting both ends down safely.

Safety note: These lessons are a reminder of skills taught in person. They do not replace hands-on instruction or supervised practice. Climbing and belaying can cause serious injury or death. Do not belay or climb without supervision until a qualified instructor has confirmed your skills, and always follow the manufacturer's instructions for your equipment.

A well-set rope runs cleanly, reaches the ground on both sides and doesn't land on anyone. A few simple habits prevent the classic mistakes: a rope that is too short, a tangled throw, or a rope thrown onto another party.

How to Set the Rope for a Top Rope, Step by Step

  1. 1 Check the length: on a top rope the rope doubles through the anchor, so it needs to be at least twice the height of the climb. Check the guidebook.
  2. 2 Find the middle: fold the rope in half by matching the two ends, then run it through your hands to the fold. A middle mark helps, but marks can fade.
  3. 3 Clip the middle into both masterpoint lockers and lock them, following the edge safety rules.
  4. 4 Lower the rope from the middle first, both strands together. Rope coming down from above also warns people below.
  5. 5 Keep lowering until about 5 m of each end is left at the top.
  6. 6 Bundle both ends so they are ready to throw.
  7. 7 Look below and yell "Rope!" right before the ends go down. Toss both bundles out and away from the cliff, or lower them down if the wind is strong or there are trees, ledges or people below.
  8. 8 Check that both ends reach the ground. If you can't see or aren't sure, tie a stopper knot in each end. This is standard practice, and it is also recommended before you rappel.
  9. 9 Before you leave the top: rope through both lockers, gates locked, masterpoint over the edge, nothing rubbing on a sharp edge.

Butterfly coil: bundle each end ready to throw

Why Lower the Middle and Toss the Ends

  1. 1 It warns the people below that a rope is coming.
  2. 2 Tossing a smaller bundle (just the ends) is more accurate.
  3. 3 If the rope catches on a ledge, throwing the ends will most likely pull it off that ledge.

From the ground

Once you are down, do the Anchor check from the CRASH check: look up and make sure the rope runs cleanly through the anchor and the two strands are not wrapped around each other.

Common mistakes to avoid

Want more Squamish climbing tips in Google? Add Squamish Climbing Academy as a preferred source.

Learn this in person

This lesson is taught hands-on with a qualified guide in:

Top-Rope Anchors ยท Intro & Anchors Weekend Combo

Questions and Comments

Have a question about this lesson? Share what you are working on, ask for clarification or join the conversation.

No comments yet. What would you like to know?