How to Set Up an Extended Rappel with a Prusik Backup

Top-Rope Anchors Learning Centre

Lesson 9 of 9

Top-Rope Anchors

Rigging the extension, tying the prusik and the CRASH rappel check.

Safety note: These lessons are a reminder of skills taught in person. They do not replace hands-on instruction or supervised practice. Climbing and belaying can cause serious injury or death. Do not belay or climb without supervision until a qualified instructor has confirmed your skills, and always follow the manufacturer's instructions for your equipment.

When rigging your rappel, extending the device away from your harness makes room for a prusik on the brake strands below it, so if you let go of the brake strand, the prusik grips the rope and stops you.

Your backup is the prusik

There is no guide belay or fireman's belay. The prusik is your backup. That is why every rappel system should be weight-tested while still clipped to the anchor, and checked, before anyone unclips.

What You Need for an Extended Rappel

How to tie a prusik, and the finished prusik: 3 wraps

How to Rig an Extended Rappel with a Prusik

  1. 1 Build the extension: girth-hitch the sling around your belay loop, then tie two overhand knots in it. This gives a near loop, a middle loop and an end loop.
  2. 2 Tether in: clip the end loop to the anchor with a locker, and lock it.
  3. 3 Prusik: tie a prusik hitch with 3 wraps around both rope strands, below where the device will be, and clip the loop to your belay loop with a locker.
  4. 4 Device: feed both strands into the device and clip it with a locker below either knot: the near loop for less extension, the middle loop for more. Lock it.
  5. 5 Prusik length: slide the prusik up. It should stop short of the device, because a prusik pulled into the device stops gripping. If it can reach, move the device to the middle loop.

Extended rappel with a prusik (front view)

Warning

When you're not rappelling, take the sling off your belay loop. Leaving it girth-hitched there all the time wears the belay loop. Pro tip: put the prusik on first. With the prusik holding the rope, it's easier to load your belay device.

Test, Check, Then Go: The Rappel Check

  1. 1 Weight-test the full system while still clipped to the anchor. Pull the rope snug through the device, sit back so the rope takes your weight, and let the prusik hold you. Your tether stays clipped.
  2. 2 Get a second check: have your partner check your whole system with the rappel check below.
  3. 3 Only then unclip your tether and stow it on your harness.
  4. 4 Rappel with both hands below the device: your top hand rests lightly over the prusik, sliding it down, and your brake hand holds the brake strands below it. To stop, let go of the prusik and let it grab. Keep your brake hand on.
Letter Rappel check before you unclip your tether
C: Carabiners Three lockers locked: device, prusik and tether. Each loaded along its spine.
R: Rope Both strands through the device the right way, device in the near or middle loop. Prusik with 3 wraps on both brake strands, too short to reach the device. Ends reach the ground, with stopper knots.
A: Anchor An IDEALS anchor. Rope through both masterpoint carabiners, gates opposite and opposed, nothing on a sharp edge.
S: Stuff Hair tied back, and loose clothing, cords and jewellery well away from the device and prusik.
H: Harness and Helmet Harness snug and buckled. Sling girth-hitched around the belay loop; prusik locker on the belay loop. Helmet on and buckled.

Weight-test while clipped in. Get it checked. Only then unclip. Your guide supervises your first rappels on the Top-Rope Anchors course.

Common mistakes to avoid

Want more Squamish climbing tips in Google? Add Squamish Climbing Academy as a preferred source.

Learn this in person

This lesson is taught hands-on with a qualified guide in:

Top-Rope Anchors ยท Intro & Anchors Weekend Combo

Questions and Comments

Have a question about this lesson? Share what you are working on, ask for clarification or join the conversation.

No comments yet. What would you like to know?