Climbing Anchor Equipment: Carabiners, Slings and Cord
Top-Rope Anchors Learning Centre
Lesson 2 of 9
Top-Rope Anchors
How anchor gear is rated, how to choose it and when to retire it.
Safety note: These lessons are a reminder of skills taught in person. They do not replace hands-on instruction or supervised practice. Climbing and belaying can cause serious injury or death. Do not belay or climb without supervision until a qualified instructor has confirmed your skills, and always follow the manufacturer's instructions for your equipment.
An anchor is only as strong as its weakest link. Knowing how carabiners, slings, cord and rope are rated and how they behave helps you choose the right tool for each job and spot worn or unsuitable gear before it matters. SCA provides all the technical equipment during the Top-Rope Anchors course.
Carabiner Shapes, Locking Sleeves and kN Strength Ratings
Common carabiner shapes, and how to read the ratings on the spine (example markings, EN 12275 minimums).
- Locking or non-locking. A locking carabiner (locker) has a sleeve, either screwgate or auto-locking, that stops the gate opening by accident. That makes lockers the right choice for critical connections: the masterpoint, your belay or rappel device and your tether. Non-locking carabiners are fine on the bolts of an anchor.
- CE and UIAA marks. CE means it meets the EU safety standard for climbing carabiners, EN 12275; the four-digit number beside it identifies the body that checked it. The UIAA Safety Label is a voluntary extra from the international climbing federation (UIAA 121, based on EN 12275).
- Reading the spine. Three ratings in kilonewtons (kN): major axis, gate closed (at least 20 kN); minor axis, or cross-loaded (at least 7 kN); gate open (at least 7 kN, or 6 kN for HMS). One kN is roughly the force of 100 kg hanging still, so 22 kN is about 2.2 tonnes.
- Why it matters. Cross-loaded or with the gate open, a carabiner can lose around two-thirds of its strength. The full rating assumes the gate is closed and the load runs along the spine.
Slings, Cordelettes and Static Rope for Building Anchors
We build anchors with slings and cord of various lengths. Sewn nylon slings (120 cm is common) are quick to rig, easy to inspect and easy to untie. A longer cordelette or static rope comes out when anchor points are far apart or far from the edge.
| Material | What it is | Good to know |
|---|---|---|
| Nylon sewn sling | Webbing sewn into a loop. Wider and bulkier, with a little stretch. Melts at roughly 220 to 260 °C. Typically rated 22 kN. | Holds knots well and is easy to untie after loading. Our usual choice for anchors and the rappel extension. |
| Dyneema sewn sling | Thin, light, ultra-strong fibre (also called UHMWPE or Dynex). Almost no stretch. Melts at roughly 145 °C. Typically rated 22 kN. | Slippery: knots hold less well and can reduce its strength a lot (up to about half in one manufacturer's tests). Hard to untie after loading. Not suitable for friction hitches: its low melting point means the heat from a sliding rope can damage it. |
| 7 mm nylon cordelette | 7 mm nylon accessory cord tied into a loop with a flat overhand bend (below). | Versatile for trees, blocks and anchor points that are spread out. Inspect the cord and the knot every time you use it. |
| Tech cord (5 to 6 mm) | Thin, high-strength cord with a Dyneema or aramid (Kevlar or Technora) core inside a nylon sheath. Often rated 18 to 22 kN, much stronger than nylon cord of the same size. | Lighter and less bulky than 7 mm nylon. Often sold pre-sewn into a loop. Dyneema-core cord melts at a low temperature, and aramid-core cord weakens with repeated bending, so inspect it closely and retire it sooner than nylon. |
| Static rope | Low-stretch rope, often 9 to 11 mm. | Useful for reaching anchors set far back from the edge. It is not designed to catch falls, so use a dynamic rope for climbing. |
How to Tie a Cordelette with a Flat Overhand Bend
Flat overhand bend, shown loose to show its path
- 1 Line up the two ends of the cord side by side, pointing the same way, with plenty of extra cord past where the knot will go.
- 2 Tie an overhand knot with both strands together, as if they were one.
- 3 Dress it: the strands lie flat and parallel, with no twists or crossings.
- 4 Set it: pull on every strand, all four, one at a time. Then do it all again, so it is set twice.
- 5 Check the tails: about 10 cm each. Long enough to be safe, not so long that a tail could be mistaken for part of the loop.
Use this bend with nylon cord such as 7 mm. For tech cord, follow the manufacturer's instructions.
Inspecting and Retiring Anchor Gear
| Gear | What to look for |
|---|---|
| Carabiners | The gate snaps shut on its own and the sleeve locks fully. No grooves or sharp edges worn by the rope, no cracks, and no corrosion that you can't clean off. |
| Slings and cord | Fading, fuzz, cuts, stiff or glazed patches, or contact with chemicals. On sewn slings, the bar tack stitching is intact. |
| Ropes | Core shots (the core showing through the sheath), soft or flat spots, or a sheath that has slipped along the core. |
- When to retire it: after a big fall or a drop onto rock if you're unsure about it, when it reaches the manufacturer's maximum lifespan, or when you don't know its history. If in doubt, replacing it is cheap peace of mind.
- Storage and care: keep gear somewhere cool, dark and dry, away from chemicals such as battery acid and fuel. Wash it with mild soap and let it air dry out of the sun.
- Retired gear: cut retired slings and cord, and mark or bin retired carabiners, so nobody reuses them by mistake.
Common mistakes to avoid
- Using a carabiner with a sticky gate, or a sling or cord that is faded, fuzzy, cut, stiff or of unknown history.
- Tails shorter than about 10 cm on the cordelette bend, or a knot that is not dressed and set on all four strands.
Want more Squamish climbing tips in Google? Add Squamish Climbing Academy as a preferred source.
Learn this in person
This lesson is taught hands-on with a qualified guide in:
Top-Rope Anchors · Intro & Anchors Weekend Combo
Questions and Comments
Have a question about this lesson? Share what you are working on, ask for clarification or join the conversation.
No comments yet. What would you like to know?
