How to Tie a Figure 8 Follow-Through Knot
Intro to Climbing Learning Centre
Lesson 3 of 11
Intro to Climbing
Step by step: the figure 8 follow-through that joins you to the rope.
Safety note: These lessons are a reminder of skills taught in person. They do not replace hands-on instruction or supervised practice. Climbing and belaying can cause serious injury or death. Do not belay or climb without supervision until a qualified instructor has confirmed your skills, and always follow the manufacturer's instructions for your equipment.
The figure 8 follow-through is the knot that joins you to the rope. It holds you every time you climb, rest or get lowered, so it is worth tying it the same careful way every time, and having it checked every time. Practise tying in with a guide on our Intro to Rock Climbing course.
How to Tie and Check a Figure 8 Follow-Through
Tying in with a figure 8 follow-through
- 1 Measure about a metre of rope from the end.
- 2 Tie a figure 8 in the rope at that point. It should look like the number 8, with the free end hanging below.
- 3 Thread the end through both tie-in points on your harness, following the same path as the belay loop.
- 4 Follow it back. Trace the end back through the knot, right beside the original strand, until every part of the 8 is doubled.
- 5 Snug and dress it. Keep the loop small so the knot sits close to your harness. Lay the strands side by side with no crossings, then pull all four strands tight.
- 6 Check the tail. Leave a tail about two closed fists long past the knot. That leaves plenty of rope to keep the knot from working loose, and your partner can see it at a glance.
- 7 Get it checked by your partner before you leave the ground: it is the R in the CRASH check.
Why Climbers Use the Figure 8 Tie-In Knot
- Easy to check. Its clear pattern of pairs lets you and your partner spot a problem at a glance, then confirm it up close.
- Secure and strong. Tied, dressed and snug, it stays secure while you climb, rest and lower.
- The standard. It is the tie-in knot taught at most gyms and climbing courses, so everyone can check everyone.
Common mistakes to avoid
- Getting distracted halfway through.
- Threading only one tie-in point, the belay loop on its own, or a gear loop.
- Letting the retrace wander off the original path, so the knot no longer looks like a neat, doubled 8.
- A big loop between the knot and your harness, or a tail that is too short.
Want more Squamish climbing tips in Google? Add Squamish Climbing Academy as a preferred source.
Learn this in person
This lesson is taught hands-on with a qualified guide in:
Intro to Rock Climbing · Intro & Anchors Weekend Combo · Youth Climbing Camps
Questions and Comments
Have a question about this lesson? Share what you are working on, ask for clarification or join the conversation.
No comments yet. What would you like to know?
